top of page

Home Protection 


Sump Pumps, Cleanouts, and More in Windsor

Protect your home from damage – Phoenix Drilling Inc. can install sump pumps, cleanouts, and backwater valves to help keep your home from being damaged by moisture and backed-up drains. Property owners throughout Windsor rely on us for our comprehensive licensed services. To request an estimate, please give us a call today

Cleanouts: Repairs and Installs 

A blocked sewer pipe can become a very costly and destructive problem for property owners. Partially blocked pipes result in slow drains, basins, toilets, and tubs, whereas fully blocked pipes result in sewage backing up the floor drains or fixtures, causing damage and health hazard. 

To easily clear blockages, a cleanout may be installed. They may be installed inside or outside the building for the purpose of investigation. We typically will install them outside the home, using less intrusive methods. 


Backwater Valve Installs 

A backwater valve can be installed on your sewer line to allow water or sewage only one way – outside your house. These should only be installed by a licensed and approved contractor. Phoenix Drilling Inc. has been approved by the City of Windsor to perform installation on backwater valves to help keep your home protected from damage and flooding.

Sump Pump and Pit Installs 

Do you know the purpose of a sump pump? Many of us have them in our basements or crawl spaces but maybe don’t fully understand what sump pumps actually do. We hear a motor running from time to time which is followed by a sucking noise.

A simple sump pump installation could save your basement from damage caused by flooding or other water catastrophes.

  • What is the Purpose of a Sump Pump?
    The purpose of a sump pump is to remove water from your basement or crawlspace and keep these areas dry. It also has several other purposes you may not realize. In cases where the water table is high, water from the soil can damage the foundation. As the water flows downward, the sump pump takes it away from the house and foundation.
  • What is a Cleanout and How Can It Help You?
    A blocked sewer pipe often becomes a costly and destructive problem for building owners. Partially blocked pipes result in the slow draining of sinks, basins, toilets and tubs. Totally blocked pipes usually result in sewage backing up through floor drains or fixtures, often causing property damage and potential health hazards. Cleanouts are the answer to fixing these issues. To easily clear any blockage that may occur a cleanout would be installed. Cleanouts can be installed inside the home to investigate the sewer pipe. A clean-out can also be installed outside the home or building for the same purpose, to access the sanitary sewer for investigation. At Phoenix Drilling Inc., we will typically install them outside and use the less intrusive method of hydro-excavation to install them.
  • How Do Backwater Valves Work?
    Your home’s sewer system allows water and sewage to flow out of the house. A backwater valve will stop water or sewage from flowing into your house should the main sewer line become overloaded. In most cases, you can check to see if it’s working properly by looking through the clear cover on the backwater valve access box. Inside the valve is a small flap that is normally open allowing water to exit your home. It also allows any sewer gases to be vented. There is a small floatation device on each side of the flap. If water or sewage starts to flow back into the house, these floaters cause the flap to lift up and close, thus preventing anything from entering your home. When the water stops coming back towards the house, gravity will allow the flap to fall into the open position again, allowing water and sewage to resume flowing out of the house. If this backwater valve is being put in an existing home, as opposed to being installed in the initial construction, a permit from your municipality is needed. We will have to cut a hole in the concrete floor, usually near the floor drain. We will dig down to the main sewer line, cut out a portion, and replace it with the new valve. These valves often have a clear top so you can see if it is operating properly. There is a lid that can be removed for cleaning. Without a properly placed and installed backwater valve, sewage could come into the basement through a floor drain, sinks, tubs, and toilets. Your home will require the installation of a sump pit and pump when you have a backwater valve installed.
  • What are Backwater Valves?
    A backwater valve (sometimes called a backflow or sewer backup valve) is a valve you can install on your sewer line and is designed to allow water or sewage to flow only one way, that is out of your house. Anytime there is a sudden heavy rainfall, the city sewer lines can become overwhelmed, causing water or sewage to flow back toward your home. If there is a sewer system backup, and you have a backwater valve in place, sewage will not be able to flow back into your house. Phoenix Drilling Inc. is an approved contractor with the City of Windsor. They currently have a basement protection program in place. Backwater valves and sump pumps with pits are all part of that program. Contact the City of Windsor to find out more or simply call our office and we can inform you of the details. Backwater valves are required by some municipalities and recommended by others. The risk of water backup increases if there is a basement in your home or if the ground floor is less than a foot above street level. If a new home has any fixtures located lower than the street level, The National Plumbing Code requires you to have a backwater valve installed.
  • How Often Should I Have My Sewage System Inspected?
    It is generally recommended that you have a licensed sewage hailer or on-site sewage system professional inspect your system every 3 to 5 years, and pump out any solids and scum when needed.
  • What Are the Signs of a Failing Septic System?
    A failing septic system can have serious health implications for you, your family, and your neighbours, plus it will pollute nearby streams, lakes, and groundwater resources. Some common signs of a failing system include: Foul odours in your home or yard Wet spongy ground or lush plant growth that appears near the septic tank or disposal field Fixtures in the house are backed up or drain more slowly than usual Sewage surfacing over the dispersal field (especially after heavy rainfall) Signs of significant algae growth in or around nearby lakes or water bodies High levels of nitrates, bacteria (E.coli) or other contaminants in well water If you suspect your system may be failing, you should call a licensed company such as Phoenix Drilling Inc. immediately. The most practical long-term solution would be to re-design and replace the system, a job that should only be completed by a qualified contractor.

Request a Free Quote

Phoenix Drilling Inc. has over 3 decades of experience in helping homeowners with all their drainage needs.

bottom of page